BumbleBerry

 

Halloween Ribbon Sculpture's

How To Make:

 

                                             Ghost #1:

Step One: Cut 5 pieces of  3/8"white ribbon 4 inches long.  'V' Cut the ends & use a lighter to keep cut ends from raveling. 

 

Step Two:  Glue 2nd piece of ribbon to the top side of the first:

Step Three:  Continue to glue ribbon pieces side by side until you have them all glued together.

Step Four:  Make a Mini Bow Using a 6 inch piece of 3/8" wide ribbon:
                                                   Fold Ribbon in half & crease it.

 

Cross ends over the center (where crease is):

 

                                            Use Needle & Thread & weave up the center:

                                           Pull thread through & wrap around center, then push
                                              through & knot.

                                                   
                                         Add a rhinestone to the center, glue to white ribbons,
                                         glue eyes on & you're finished!

                                                                         Ghost #2

                                     Step One:   Cut 4 lengths of 3/8" white ribbon into 4/12 or 5 inch pieces
                                      and 'V' cut both ends & heat seal:

                                       Step Two: Fold each piece in half to crease, then put a tiny dot
                                       of glue in the crease & fold over:

                            
                                    Step  Three: Put a dot of glue at the top, side of one piece
                                       and glue the next one to it.  Repeat this step until all pieces
                                       are glued together.  Add a Mini Bow & eyes:
                                                                                                    . 

                                                                       Finished!

 

Pumpkin

 



                            

 

Step One:  Cut 4 pieces of 3/8" orange ribbon into 4 inch lengths.
Don't forget to heat seal the ends!

Fold each piece in half & crease, so you'll know where the center is.

Glue first two pieces into an 'X' shape.

 

Step Two:  Glue other pieces like the ones in the picture below:

 

 

Step Three: Take the bottom ribbon & join the ends so that they make a circle:

 

Step Four:  Do the same for the next piece:

 

Continue until you've joined all pieces & it resembles a ball:

 





 

Make the Stem:

Cut a small piece of 3/8" brown ribbon, fold in half & glue at the bottom:

Place a small amount of glue in the center of the cut end & glue ends together:



 

Now glue to the top.  Glue on some small green pieces to make leaves if you want.

(I cut 3/8" korker ribbon in half lengthwise to make mine)

 

And you are Finished!